I have searched the FAQs and the Olympus System Chart for any info on the
three-pin socket at the side of the Bounce Grip 2. A dealer said it was for
operating the unit from mains power but had never seen a cable. No mention
in the Olympus System Chart either. Can anyone tell me please:
1. If it is a power socket, is it for 110V or 220V - no voltage switch to be
seen?
2. Does it just power the unit or can it recharge batteries too?
3. Is a cable available from Olympus - whats its designation?
4. What are the pin connections - (there are three), is one an earth or
ground?
5. Are the pin connections the same as for the T32 (T20?) flash?
Regards
Trevor J. Noble
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|